Fountain PURE C Manuel De L'utilisateur page 10

3 FIRST INSTALLATION*
1. Remove the machine from its box carefully and check for any faults or damage.
2. Place the machine on a suitable work surface near to a 230VAC 50Hz 15A socket.
3. Fill the machine with drinking water up to the "MAX" mark on the reservoir.
4. Plug in the machine's power lead and switch it on using the main On/Off switch.
5. The indicator light on the front panel will flash orange and green = the machine is warming up.
6. Wait for the water to heat up (1 to 2 minutes) = the indicator will change to steady green.
7. Place a large container under the drinks dispenser.
8. Press on the hot water dispensing button to run water via the nozzle into the container.
9. Empty the container and repeat steps 7 and 8 until the reservoir is completely empty.
10. Fill the machine with drinking water up to the "MAX" mark on the reservoir.
11. Position the drip tray and lock it in place by sliding it slightly to the left.
4 FITTING THE CARTRIDGES
1. On each cartridge holder there is a device for limiting the quantity of product
dispensed, whose position should be adjusted specifically for the cartridge
fitted.
2. A diagram on the cartridge being fitted shows the recommended position of
the limiter.
3. Fit the limiter in the cartridge holder, adjusted as indicated.
4. Fit the cartridge in the holder.
5. Repeat the operation for each cartridge holder, after carefully checking the
position of the limiter for each cartridge.
Limiter
5 ADJUSTING THE COFFEE DOSE (STRENGTH OF DRINK)
The dosage in the automatic coffee dispense section can be adjusted.
To adjust, remove the adjuster screw (1) and use the small lever (2) to slide the
mechanism in or out so that screw hole lines up with one of 5 holes in the
mechanism.
Slide the lever backwards for a weaker drink, forwards for a stronger drink.
Replace the screw when the desired setting is reached.
All manuals and user guides at all-guides.com
10
Position of the limiter
(supplied)
2
p
a
d
1
of
cof
fee
car
trid
ge