Usage Notes; Important - Matco Tools DT6 Mode D'emploi

OPERATING INSTRUCTION:
1. Remove tire valve cap.
2. With clip-on air chuck lever depressed, firmly press chuck onto tire valve stem and release lever, and ensure that
no air leaks.
3. Press the grip to inflate. Press the grip half-way to deflate.
4. To turn on the inflator, press the ON/UNIT/LIGHT button. If it does not work, the inflator will be turned off
automatically 90 seconds later.
5. When the inflator is on, press the ON/UNIT/LIGHT button to turn on the backlight in order to read the pressure in
dark. The backlight will diminish automatically in 10 seconds. Backlight will not be activated by turning on the
inflator, can only be activated by pressing the ON/UNIT/LIGHT button.
6. To change unit, when the inflator is on, press ON/UNIT/LIGHT button for at least 3 seconds. Then, press
ON/UNIT/LIGHT button shortly after to choose the desired unit. The unit chosen will be set as default for
following usage.
7. The inflator's battery is 2*AAA, if voltage is low, the low battery signal on the top left of the LCD display will be
flashing continuously to remind user to change the battery.
8. The measuring range is 0.2-12 bar (3-175psi). Reading resolution is 0.01 bar (0.1psi). Maximum inlet pressure is
15 bar (218psi).

USAGE NOTES:

1. Inflator's working pressure is 0.2-12 bar (3-175psi), Max Inlet Pressure is 15 bar (218psi).
2. Maximum Pressure is above 17 bar, the LCD will show "----", no actual value, and the inflator may be damaged.
1.
Peel back rubber sleeve
DIGITAL TIRE INFLATOR

IMPORTANT

To avoid the risk of personal injury, especially to the eyes, face or skin,
DO NOT direct the stream at any person.
BATTERY INSTALLATION INSTRUCTION
2.
Pry the cover open with fingernail or
flathead screwdriver (care to hold down cover,
as cover is under spring tension)
4.
Snap battery cover shut
5.
Reinstall rubber sleeve
Page 2
DT6
DT6G
DT6O
3.
Install 2 AAA batteries
in indicated orientation
1809273-14