Thule Omnistor 6300 Manuel D'installation page 22

General marks and Thule warranty
EN
GENERAL MARKS:
- Installation must be carried out by a qualified person.
- Check if you have a solid back ground for installation of the adapters of
the awning. Fixation must be carried out by bolts and nuts and
counterplate and by preference also glued with SIKA 252. Contact your
dealer or manufacturer of the vehicle. Before drilling, be sure that there is
no obstacle at the inside (for example electric cables, gas pipes and so on).
- The adapters must support the awning at the awnings spring arms for
a correct and stable mounting. When this is not possible use a full length
adapter.
- In order to get a watertight installation, use acid free silicone or SIKA 252
to fill up the drilled holes.
- For the mounting height of the bottom mounting brackets ask your dealer
or manufacturer.
- An awning is a sun and not an all-weather protection. The awning should
be closed in case of storm, snow or heavy rain fall (avoid formation of a
water pocket).
THULE WARRANTY:
1. The warranty for the THULE awning to the original buyer is two years
from date of invoice.
2. The warranty covers replacement of parts arising from defects and from
the inability of the awning to perform its intended function.
3. In case of a defect, consult your dealer with original invoice.
4. Defects, which in our judgment occur from misuse, negligence or
accident, are not covered by the warranty. In addition, the warranty does
not apply if the product is installed or handled improperly or if the awning
has been altered in any way or has been repaired by unqualified persons,
or if the serial number and/or date has been altered or removed.
22 6CA904-00