Table des Matières
Publicité
F E AT U R E S - O P E R AT I O N S
Figure 4
Base
Power cord
Figure 5
Front View
Thermostat
Oscillation Button (BHH7522MX only)
Control
Mode Control
Figure 6
Thermostat
Oscillation Button
Control
(BHH7522MX only)
Rear View
Reset
Button
Cord Wrap
Power Light
Mode
Control
ASSEMBLY INSTRUCTIONS
Carefully remove your heater from the box. Please save
the carton for off-season storage.
Base Assembly
There is a Base attached to the backside of the heater
when packed inside the box, you need to take out the
Base to prepare for assembly (Figure 1):
1. Pull the power cord through the center hole of the Base.
2. Line up the Tabs at the bottom of Heater Housing into
the Base (Figure 2).
3. Rotate the Base into the Heater Housing until the
Base is securely locked (Figure 3).
4. Run the Power Cord through the cord channel located
underneath the base. (Figure 4).
5. Turn the heater right side up on a flat level surface
prior to beginning operation (Figure 5).
6. Use the cord wrap at the backside of the heater to
hide extra cord when the heater is not in use.
OPERATING INSTRUCTIONS
1. Make sure the unit is in the Off position before
plugging the heater into the outlet.
2. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500
Watts, this unit draws 12.5 Amps.
Mode Control
Turn the Mode Control to the desired setting:
O - Off Mode
If you want to shut off the heater at any time of
operation, turn the Mode Control to Off (O) position.
Power Light may remain lit until the heater is unplugged.
1 - Low Heat
The heater will run continuously at 900W.
2 - High Heat
The heater will run continuously at 1500W.
Publicité
Table des Matières
