Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FILLING
1.
Place the steamer as shown (Fig. E). You can also place your steamer on the heat resistant storage
bag.
2.
Open the water inlet cover (Fig. B).
3.
Pour slowly, to let the air in the reservoir escape, otherwise you'll cause an air lock and the water will
overflow.
Don't fill past the max marking or water will escape in use.
4.
•
To refill at any time during use, turn the steamer off by pressing the power button until the blue
indicator light goes out, unplug from outlet, and follow the above procedure.
•
After refilling, allow to reheat for 60 seconds and then prime the pump by holding the steam trigger
until steam forms.
USING
If the label says "do not iron" or shows this icon i, fit the delicate attachment and make sure to test
•
on an inconspicuous area prior to steaming the entire garment.
•
If the label says "do not steam" or shows this icon
1.
Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on
a shower curtain rail, or in an open doorway. Alternatively, place the garment on a bed or towel. You
can use the heat resistant bag between the bed/towel and garment if required.
2.
Fit any attachment you wish to use.
3.
Plug the steamer in then press the power button. The blue power button light will slowly flash,
indicating that the steamer is heating.
4.
After about 60 seconds the power light will stay on, indicating your steamer is ready to use.
5.
Prime the water pump by holding steam trigger until steam forms.
6.
To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the
steamer. When the trigger is released, the steam will stop.
•
To generate a constant flow of steam without holding the trigger, press the steam trigger and then
slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn
the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.
7.
With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping
the head of the steamer in contact with the fabric (Fig. C).
8.
When you have finished, press and hold the power button until the blue light goes out (about 3
seconds) and unplug.
•
After ironing or between garments, set your steamer down with the handle resting on a flat, stable
surface. You can use the heat resistant bag to rest your steamer on (Fig. E).
Ceramic heated plate
Your steamer features a ceramic heated plate that helps smooth out wrinkles and creases on the areas of
garments that are more difficult to reach with steam alone. The temperature of the plate is safe for all
ironable fabrics.
To use, hold the plate of the steamer directly against the fabric. Don't fit any of the attachments. Steam the
garment with slow, downward strokes, keeping the head of the steamer in contact with the fabric. You can
use the heat resitant bag to iron on (Fig D).
Important: Always make sure that the surface you use to iron on will not be affected or damaged by heat
or steam!
Auto shut off
If you haven't used the steam trigger for approximately 8 minutes, your steamer will enter auto shut off
mode. In auto shut off mode, the blue light will flash. To restart your steamer, press and hold the steam
trigger for a few seconds until your steamer begins to steam again and the blue light stops flashing.
, do not steam the garment.
m
6
Publicité
Table des Matières
