Panel Mounting; Electrical Wiring Diagram - EMKO EZM-3735 Mode D'emploi

2.3 Panel Mounting

1-Before mounting the device in your panel,
make sure that the cut-out is of the right size.
2-Insert the device through the cut-out. If the
mounting clamps are on the unit, put out them
before inserting the unit to the panel.
2.4 Removing from the Panel

4. Electrical Wiring Diagram

Note-1 : For 230VV , 115VV or 24VV power supply;
10...30VZ power supply; input 4 is "-", input 5 is "+".
1
2
1
2
3
3
3- Insert the mounting clamps to the fixing sockets
that located left and right sides of device and make
the unit completely immobile within the panel
1-Pull mounting clamps from left and right fixing
sockets.
2-Pull the unit through the front side of the panel
Before starting to remove the unit from
c
panel, power off the unit and the related
system.
N
L
input 4 is "L", input 5 is "N", for
3
Digital Input
Pause
Supply Voltage Input
V ±
230V ( %15) 50/60Hz
V ±
115V ( %15) 50/60Hz
V ±
24V ( %15) 50/60Hz
Z
10..30 V
Must be determined in order.
Relay Output
5