A.M.P iso BXH-200NC Manuel D'utilisation page 3

Pairing device with your headset
4
Pairing audio receiver to your Bluetooth mobile phone or
other Bluetooth devices, for the first time only. The audio re-
ceiver will store paired device, so you don't need pair it every
time. To put audio receiver into pairing mode, press and hold
the pairing button for six seconds from power off state and
wait for the blue and red led flash alternative that indicates
the headset is into the paring mode. Operate your Bluetooth
mobile phone or other Bluetooth device to start Bluetooth
function. Find the headset "BXH-200NC", press the pairing
code "0000" The blue LED is start flashing, the audio receiver
is in connected mode.
5
Working in AV mode
• Short press MFB key to toggle play/pause action
• Short press Vol+ or Vol- to adjust volume one step
• Short press Forward or Backward button to select songs
6 Working in headset mode
Standby mode:
• Double click MFB key to init voice dial function
• Short press MFB and NC key to init last number redial
function
• Press 3~5 seconds Vol- and Forward key to clear paired list
Incoming call (ring) mode:
• Short press MFB key to accept phone call
• Long press MFB key to reject incoming call
In call active mode:
• Short press Vol+ or Vol- to adjust volume
EN
• Long press MFB key when hear a beep tone to toggle call
between headset and cellular phone
• Short press MFB key to end call
• Long press Vol+ and Vol- to toggle microphone mute
NC modes
7
• Short press toggle NC on/off mode
• When NC turns on, green LED will turn on.NC turn off, green
LED turn off.
Led statuses
8
POWER ON
POWER OFF
PAIRING
STANDBY MODE
ANC MODE
A2DP AAC MODE
A2DP SBC MODE
A2DP apt-X MODE
HEADSET ACTIVE MODE
LOW BATTERY INDICA TION
AUTO SHUTDOWN
9 Trouble shooting
If the audio receiver does not work, try the following:
-Ensure connecting devices are charged not in low battery state
-Turn off all devices and then turn them on in order to shown
in this guide
-Ensure devices are within 10 meter range
-Ensure the audio receiver is connected by check the blue
LED flash
Note 1: Some A2DP source like 3.5mm interface transmitter
can not support AVRCP profile, so it can not do remote
control function.
EN