Getting Started; Turn On/Off; Setup Channel - DNT Sound2move Mode D'emploi

Operation All manuals and user guides at all-guides.com
If you want to move the base station, be sure that the loudspeaker boxes are fi xed.

Getting started

Connect the charger with the DC-jack and the plug. Connect the required audio-system with the according
audio cable of the base. In case the base is connected with a headset output, it is advisable to set the volume
of the signal source to 1/3.
Turn on
The loudspeakers have a separate on/off switch, which is combined with a volume control. The loudspeaker
system should be activated in the following order:
Press ON/OFF button to turn the base station on.
Now switch the loudspeakers on. The volume knob should by set to center position. A blue LED indicates,
that the loudspeaker is on.
Wait 5 seconds.
In the next step set the required volume at the base station with the (+ -) buttons.
It might be necessary to readjust the volume of the signal source, if the speakers output
power is too low.
If the loudspeakers are switched to power on, the batteries are discharged although now
music is transmitted.
Turn off
Turn the volume knob to OFF position.
The blue indicator turns off.
Switch the base station off with the ON/OFF button.
Recharge the battery
The loudspeaker boxes have a built-in Li-Ion battery. When the speaker placed on the base station under
POWER ON mode, it automatically starts to charge. While charging the light is red. It turns green when fully
charged. Recharging takes about 3~4 hours for a full charge, depending on the charging condition.
Operation
A radio link is built as soon as the base station and the speakers are switched on.
Pay attention that the loudspeaker boxes are placed on a straight not leading surface.

Setup channel

After the channel has been chosen, the two speakers remembers the frequency. If the unit receives any inter-
ference while it is playing, switch to another channel at the rear of the base station.
Sometimes the speaker will give a noise after power on,which is a normal phenomenon and results from
wireless searching and will stop as soon as the base and the speakers are wireless paired. In order to avoid
interference, please don't turn on other wireless devices simultaneously.
- 14 -