Publicité
Les langues disponibles
Les langues disponibles
Adjustable Wall Mount Arm (Figure 4.)
1.
Loosen (3) hex head screws located on arm mounted
on back of the fixture and carefully set aside the cover
plate.
2.
Align pole side arm to the fixture side arm and route
the wires from luminaire through the slot of the pole
side arm.
N
ote:
Ensure the luminaire supply leads do not get pinched
between the two arms.
3.
Adjust the angle as needed for aiming.
N
ote:
Do not tilt the luminaire more than 60 degree above
horizontal.
4.
Slide lock washer and flat washer onto (1) 1/2-13 grade
8 bolt and Install the bolt through the hole of pole side
arm and tighten into the luminaire side arm. Tighten to
40 ft-lbs.
5.
Route the wires through the wire tie provided in the
pole side arm and through the wire hole of pole side
arm.
6.
Line up the holes in decorative wall plate with holes on
the pole side arm.
7 .
Slide lock washer and flat washer onto the (2) 1/2-13
bolts and install the bolts from inside the pole side arm
into the holes of the decorative plate.
8.
Install the provided nuts with lock washers on opposite
end of the decorative plate and Hand start each bolt
until it catches the nuts.
9.
Tighten (2) 1/2-13 bolts to 40 ft-lbs., and set the
assembly aside.
10. Pull the supply wires out of junction box (not supplied)
and through the large hole in the center of the
attachment plate.
11. Secure attachment plate to the wall using four bolts
(not included).
12. Pull the supply wires into the center hole of the
decorative wall plate and into the fixture assembly.
13. Hang the decorative wall plate onto the attachment
plate and tighten the locking screw located at the
bottom of the decorative wall plate to 15 in-lbs.
14. Reinstall the cover plate on the housing side arm with
(3) hex head screw.
All manuals and user guides at all-guides.com
Installation Instructions – Galleon LED Floodlight
Cooper Lighting Solutions
CAUTION
Failure to install this plate could cause damage to the
arm.
15. Connect the supply wires to appropriate luminaire
leads:
Supply side ground wire to green luminaire lead.
•
Supply side neutral wire to white luminaire lead.
•
Supply side line voltage wire to black luminaire lead.
•
16. Use (5) hex head screws to install cover plate with
gasket onto the pole side arm.
Luminaire Side Arm
1/2-13 Bolt
Pole Side Arm
Gasket
Locking Screw
Pole Side Arm
Cover
Decorative Wall Plate
Figure 4.
IB506001EN
Pole Side Arm
Split Lock Washer
and Hex Nut
Attachment Plate
Wall Gasket
Installation instructions
5
Publicité
