Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING: Do not operate the inflator when the car
engine is running.
nOTE: Make sure that your 12 Volt accessory socket is live.
On some vehicles the accessory socket may only become
live when the ignition key is in the accessory position.
Installing and Removing the Battery
Pack (Fig. D, E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack into the battery port
the battery pack with the rails inside the battery port and
slide it into the handle until the battery pack is firmly seated
in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
22
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. D
Fig. E
Switching On (Fig. F,G)
WARNING: Risk of Bursting. Do not leave unit
running unattended. Overinflation of tires and
other items could result in serious injury and
property damage.
nOTE: When power is supplied to the inflator by 12v, 20v
battery, or 120V AC the LCD display will remain on for
approximately 10 minutes before the display shuts off/goes
into sleep mode. This occurs when the unit is not operating.
To wake up the system, the user will need to push the
pressure mode / reset button
turn on and the inflator is ready for use.
•
Before switching your inflator on decided which power
source you will be using; 12V DC adapter, 120V AC plug
or a 20V MAX* battery pack.
•
To use the 12V DC adapter, or 20V MAX* battery pack
press the AC/DC power switch
the unit to DC.
•
If using the 12V DC cord, ,always fully extend the 12V DC
cord before each use.
, align
15
15
22
. At this time the LCD will
5
located on the front of
1
-
Connect the 12V DC adapter
12V DC accessory socket.
To use the 120V AC cord, press the AC/DC switch
on the front of the unit to AC.
•
If using the 120V AC cord
cord before each use.
-
Connect the 120V AC plug
outlet or an approapriate sized extension cord that
is plugged into a wall outlet.
Fig. G
To turn on high-volume
The high-volume hose is meant to be used for objects that
hold large amounts of air, such as air mattresses, rafts, and
swimming pool floats.
nOTE: The high-volume mode DOES NOT have an auto
shut-off feature.
1. Attach the high-volume hose
pump inflator connection
volume hose" section.
2. Insert the high-volume hose
into the object being inflated.
3. Press the high-volume side of the mode power
switch
2
, indicated by the air mattress symbol.
4. To turn off, push the power switch to the center position.
To turn on high-pressure
The high-pressure hose is meant to be used for objects that
need more air pressure, such as tires and basketballs.
1. Remove the high-pressure hose
2. Attach a nozzle as described in the "Universal valve
adapter" section.
3. Insert the nozzle into the object being inflated.
4. Press the high-pressure side of the mode power
switch
2
, indicated by the tire symbol.
5. To turn off, push the power switch to the center position.
Fig. G
Deflate using the high-volume hose
(Fig. H)
WARNING: Beware of objects being ejected.
When deflating, large amounts of air will exit the
English
14
into your vehicles
located
1
13
, always fully extend the
into either a wall
13
1
7
to the high volume
12
as described in the "High
, or it's tapered nozzle
7
from the storage.
10
2
8
9
Publicité
Table des Matières
