Unpacking Instruction; Ground/Lift Switch - Power Dynamics PDX30 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
OVERVIEW
1.

Ground/Lift switch

Set the switch to the Ground position for normal operation
(unpressed). To eliminate hum or buzz that's caused by a
ground loop, move the switch to the Lift position (pressed).
2.
Balanced XLR output
Balanced outputs connect to the mic/line inputs of a sound
mixer or PA system.
3.
Battery On/OFF switch
Switch 9V battery On or Off. When switch is off and LED
light up, 48V phantom power is receive.
4.
Input Jack 6.35mm (1/4")
The Jack 6.35mm (1/4") can be used to connect an
instrument such as a guitar or keyboard.
5.
Output Jack 6.35mm (1/4")
The Jack 6.35mm output connector for passing the input
signal through to a stage amplifier or monitor system.
6.
-25dB Switch
The switch attenuates the signal level from loud sources
like an electric guitar or keyboard. Set the switch to O dB
for normal operation. If you experience distortion, switch
the pad to -25 dB..
7.
Battery compartment 9Volt
The PDX30 can operate on a 9 Volt battery or by using 24- 48 volt phantom power. Phantom power is available on the XLR
cable (connected to the Balanced Output) the PDX30will automatically switch to phantom power and disconnect the 9 Volt
battery.
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

172.782

Table des Matières