Archos DEx-CDRW Guide D'installation page 8

Note concerning USB Driver installation for Windows ME - 2000 & XP:
The Windows USB mass Storage driver will be installed automatically. Follow steps listed below
for installation:
•
Turn on your computer and wait for Windows to finish booting.
•
Insert USB cable to an open USB port on your computer. Follow steps listed below to
complete installation:
I :
MPORTANT
• In order to use the Archos Dex-CDRW properly, you must update the USB drive.
• Follow steps listed below to complete installation:
1. Go to Control Panel | System, click on Hardware tab and Device Manager...
Double click on Universal Serial Bus Controllers,
double click on USB Mass Storage Device,
click on Driver tab,
click on Update Driver...
2. Welcome to the Upgrade Device Driver Wizard , click Next.
3. This Wizard upgrades drivers for the following hardware device: USB Mass
Storage Device. "What do you want the Wizard to do?
4. Select Search for a suitable driver for my device. (Recommended).
5. Click Next.
6. Where do you want Windows to search for the driver files?
Put the check mark on Floppy disk drives box, and uncheck all other boxes;
7. Insert Dex-CDRW installation diskette driver in floppy drive and click Next.
8. Windows found a driver that is closer match for this device than you
current driver. located in A:\ Click Next.
9. To complete the Upgrade Device Driver Wizard – USB Storage Adapter V2, click
Finish.
All manuals and user guides at all-guides.com
Found new hardware wizard will pop up. Windows will install
USB Storage Adapter,
USB Mass Storage Device,
IDE-CD R/RW...Device, and
CD-ROM Drive using standard Windows drivers.
No driver files will be needed from Archos.
- 8 -