Haussmann Xpert DMT109 Manuel De L'utilisateur page 21

All manuals and user guides at all-guides.com
OPERATION
WARNING! Ensure power source voltage is 120 V. The voltage of the power source
!
must be consistent with the voltage specified on the label of the tool.
SWITCHING ON AND OFF
To start the tool, push the On/Off switch 2 forward so that the "I" is indicated on the
switch.
To switch off he tool, push the On/Off switch 2 toward the rear so that the "0" is
indicated on the switch.
SPEED SETTING
The tool is equipped with an electrical speed adjustor. The adjusting disk is marked
with figures: "1,2,3,4,5,6." You can increase the spreed when you turn to higher
number. To decrease the sped, turn the adjusting to lower number.
OPERATING INSTRUCTIONS
Note: Do not cover off the venting slots of the tool while working, as this reduces the
working life of your tool.
!
While working with accessories make sure that the covering of the accessories is
undamaged.
OPERATING PRINCIPLE
Due to the oscillating drive the application tool/accessory swings up to 21,000 times
per minute at an angle of 3°. This allows for precise work in narrow spaces.
SAWING
Use undamaged, faultless saw blades only. Deformed, blunt saw blades or saw
blades that are otherwise damaged can break.
When sawing light building space materials, observe the statutory provisions
and the recommendations of the material suppliers.
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with segment saw blades in wood, particle board, building materials,
etc., check these for foreign objects such as nails, screws, or similar. If required,
remove foreign objects.
SANDING
The removal rate and the sanding pattern are primarily determined by the choice of
sanding sheet, the preset oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding capacity and extend the service
life of your tool.
Pay attention to apply uniform sanding pressure; this increases the working life of the
sanding sheets. Intensifiying the sanding pressure does not lead to an increase of the
sanding capacity, but to increased wear of the tool and the sanding sheet.
For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also
possible to work only with the tip or an edge of the sanding plate.
A sanding sheet that has been used for metal should not be used for other materials.
21