Care And Storage; Important - uComfy Shiatsu Mode D'emploi

PLEASE READ ALL USER INSTRUCTIONS PRIOR TO OPERATING
THE SHIATSU MASSAGER.
IMPORTANT: Do not stand inside the unit or apply excessive
pressure to the massager. This may significantly slow down
or stop the motor, causing the unit to overheat.
1. Connect the provided adapter to the massager, then plug into
the wall outlet. See Diagram on right. The Power Button will start
flashing red.
2. Choose a comfortable chair of equal height. Place your
legs into the slots and relax.
3. Press the Power Button to turn the massager on. The unit will
beep one time and the LCD will display "15" and then will begin the countdown.
4. The massager will start operating automatically.
5. There are a total of 5 levels (P1-P5). The default setting is level 1
with Heat (Massage Mode button will remain
the and buttons will be flashing and the Heat
• If desired, press the button to move to level 2 (
flash RED) and the LCD panel will briefly display P2.
• During the massage, feel free to change levels according
to your comfort level.
To increase the level, press the button.
To lower the level, press the button.
The LCD panel will briefly display the selected level.
USAGE
CONNECT
THE ADAPTER
BLUE during operation,
will stay on).
will
7

CARE AND STORAGE

6. You will feel the air pressure increasing and then releasing during the duration of the massage.
For optimal massage experience, you will feel the change of direction and type of massage.
If you feel that a certain level is too high or too low, use the
Refer to point 5 on the previous page.
7. To turn the heat off, press the Heat Mode button
function is off).
8. To turn the unit off at any time, just press on the Power Button. The next time you turn it back on,
it will go back to the default setting level 1 (P1) - 15 minutes.
9. Unplug the unit when done using the massager.
CARE AND STORAGE
- Before cleaning, always make sure to turn off the unit from the control panel first. Then unplug from the
electrical outlet.
- Do not use any abrasive cleaners when cleaning the unit.
- Use a dry cloth when cleaning the massager. Never use the damp cloth to clean the control panel and
massager unit.
- When not in use for long periods of time, store the massager in a dust and moisture free environment
with the cord coiled. Do not wrap the cord around unit.
- Do not leave the unit under direct sunlight for extended periods of time.
- Do not store the massager unit near the heat source.
- If the massager unit malfunctions or brakes down, never try to repair it yourself, consult a licensed
electrician.
and buttons to adjust the level.
(the red light will be off indicating that the heat
8