I N S T A L L A T I O N
SMART CONTROL
PLUG
3
Smart Control Plug
Item #82001
1
No.
1.
Required
• Adequate Wi-Fi coverage reaching to the unit (2.4 GHz networks
supported)
• Aquascape Smart Control App (available on iOS or Android App Store)
Safety Information
WARNING: It is recommended whenever working in or near water to
have all electrical devices plugged into a ground fault circuit interrupter
(GFCI) that has been installed by a licensed electrician.
• The power cable should be protected at all times to avoid punctures,
cuts, bruises, and abrasion.
• Operating the Smart Control Plug outside of the 1500 watt (1000 watt
per plug) operating range voids the product warranty and may damage
or shorten the life of the unit.
IMPORTANT: Aquascape, Inc. is not responsible for losses, injury,
or death resulting from a failure to observe these safety precautions,
misuse, or abuse of pumps or equipment.
Installation
PAIRING PROCEDURE
• Plug the Smart Control Plug into an outdoor-rated
GFCI or indoor power source, and the unit will
automatically enter pairing mode.
NOTE: The blinking blue light on the face of the
unit indicates the plug is in pairing mode and
ready to be connected.
• Download the Aquascape Smart Control App
(available on iOS or Android App Store).
• Open the Aquascape Smart Control App and click
'Create New Account' (Ex. 1).
NOTE: If you already have an account, login with
your username and password.
facebook.com/aquascapeinc
youtube.com/aquascape4
pinterest.com/aquascapeinc
Contents - #82001
Description
Smart Control Plug
Ex. 1
I N S T R U C T I O N S
• Once logged in, click the three
dashes in the upper, right-hand
corner of the home screen (Ex. 2).
• Click 'Add New Device' (Ex. 3).
• Enter the Wi-Fi network and
password for the network to which
the unit will connect (Ex. 4).
NOTE: Adequate Wi-Fi coverage
is required (2.4 GHz networks
supported)
• Continue to follow on screen
instructions to complete the pairing
process.
• To reset the device to factory
defaults, press and hold the pairing
button for ten seconds and release
when the light begins rapidly
flashing (Ex. 5).
Troubleshooting
• Device won't pair
– Make sure the outlet is receiving power
– Make sure you have adequate wireless coverage to connect the
device (2.4 GHz networks supported)
– Reset the device to factory defaults
– Make sure the ground-fault circuit interrupter (GFCI) is not tripped
Warranty Information
3 YEAR WARRANTY
Aquascape Smart Control Plug is guaranteed for three years from
date of purchase. Proof of purchase required. Warranty does not
cover damage resulting from negligent handling, misuse or lack
of care. Warranty is valid against defects due to material and
workmanship only. Products returned must be cleaned, sanitized,
or decontaminated, as necessary, prior to shipment to ensure
that employees will not be exposed to health hazards in handling
said material. All applicable laws and regulations shall apply. The
sole obligation shall be to replace the defective unit with a suitable
replacement unit. Units should be checked for proper operation
prior to returning as defective. No liability for loss or damage of any
nature or kind, whether arising out of or from the use of the product,
whether defective or not defective, is assumed by Aquascape, Inc.
or it's affiliates.
For more information about our company or products, please visit our website at
aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426
©2019 Aquascape, Inc. • All Worldwide Rights Reserved
Ex. 2
Ex. 3
Ex. 4
Ex. 5
10/19