Connect Vent; Reverse Door Swing - KENMORE ELITE HE5 Steam 110.C9772 Serie Guide D'utilisation Et D'entretien

4. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.

Connect Vent

1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Check that the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
2. Move dryer into its final location. Do not crush or kink vent.
3. (On gas models) Check that there are no kinks in the flexible
gas line.
4. Once the exhaust vent connection is made, remove the
corner posts and cardboard.

Reverse Door Swing

You can change your door swing from a right-side opening to a
left-side opening, if desired.
NOTE: For ease of installation, you may want to use 2 or more
people to remove and reattach the dryer door.
Remove the door
1. Place a towel or soft cloth on top of the dryer or work space
to protect the surface.
2. Open the dryer door. Remove the 5 screws that hold the door
hinge on the front panel of the dryer.
A
C
A. Dryer front panel
B. Dryer door
C. Screws
3. Remove the door.
4. Lay the dryer door on a flat, protected surface with the inside
door assembly facing up.
Remove the 5 screws to release the outer door assembly
from the inner door assembly, as indicated below. See
illustration. It is important that you remove only the
5 indicated screws.
5. Lift the inner door assembly off of the outer door assembly.
Set the outer door assembly aside.
All manuals and user guides at all-guides.com
Reverse the hinge
1. Place the inner door, screw head side up, on the work space.
2. Remove the 4 hinge screws that hold the hinge to the door
3. Move the large hole screw to the opposite side. Remove the
B
4. Move hinge to the other side and reattach with the 4 screws
5. Set the inner door assembly aside.
Reverse the door handle
1. Place the outer door assembly face down on work space.
2. Remove the 6 screws that hold the intermediate door to the
and remove hinge.
A
A
A. Hinge side screw
B. Locator pins on hinge
C. Top side screw
2 plug screws and plastic plugs, and insert them in the
original screw holes on the opposite side.
A
B
A. Hinge screws
B. Large hole screw
C. Plug screws and plastic plugs
removed in Step 2. Make sure locator pins line up in holes
and drive the top 2 screws in place first to help drive locator
pins into proper location.
outer door assembly. Remove the intermediate door, and set
hinge shield aside. Remove the hinge hole cover.
B
A
A. Intermediate door
B. Hinge shield
C. Hinge hole cover
B
C
C
B
C
C
13