Using Your Ibox - Audiovox iBox 200 Mode D'emploi

All manuals and user guides at all-guides.com

Using your iBox

• Select the adapter faceplate that fits your iPod model and insert it
into the depression on the device (Fig. 1, No. 7). Original iPod adap-
ter faceplates may also be used.
• Remove the protective film on the remote control's battery compart-
ment (Fig. 3, Item C).
• Remove the plastic protection on the iPod system connector (Fig. 1,
No. 8).
• Connect the output cable on the separate power supply unit to the
power supply input on the device's rear (Fig. 2, No. A).
• Plug the mains connector into a mains socket. The device is now in
stand-by mode.
• Place your iPod on the system connector and lightly press it down
until it stops. The iPod is inclined slightly towards the rear.
Note: The iPod battery is charged for as long as it is connected to and
is supplied with power through the iBox 200.
Changing the remote control's battery
The battery needs changing when the remote control stops working
properly. Open the battery compartment (Fig. 3, Item C) and insert a
new battery (lithium battery, 3V CR2025). Please ensure that the poles
match as indicated in the battery compartment!
Old batteries constitute hazardous waste and must be disposed in
accordance with current regulations.
14