Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
notice_VL940MPT
6/02/06
- Insert the spring (15) in the stand (3).
- Assemble the stand (3) and the base (1). Fix them with the 4 screws (2).
- Fix the motor (5) on the stand (3) using screw (4) (remove the lock screw, insert the motor and fix it with
screw).
- Fit the rear guard (6) on the motor shaft (5) (handle on the top). Secure the guard to the motor body with
the set screw (4).
- Push the fan blade (8) onto the motor shaft (5). Fix the fan blade with the screw (7). Check that the fan
blade rotates freely by turning with your hand.
- Unscrew the guard securing clip (10). Press the rim of the front guard (9) onto the rear guard (6). Close
the clip and tighten the screw.
WITH THE CONTROL PANEL OR WITH THE REMOTE CONTROL
FAN SPEEDS
Press
touch to start the appliance or M/A on remote control.
Press again
to adjust the fan speeds, as shown below (or use I, II, III on remote control) :
Start
low speed I
middle speed II
TIMER
To activate the timer, press "Temps" touch several time until the desired time appears, or 1h / 2h / 4h on
remote control.
DISPLAY:
There are three light indicator.
The red colour is for the fan speed, the green colour is for the timer and the orange colour is for both
function (in the same time).
15:03
Page 9
ASSEMBL
Y OF THE APPLIANCE
ASSEMBL
Y OF THE APPLIANCE
USING OF APPLIANCE
USING OF APPLIANCE
M/A
1h
1h
III
2h
II
4h
I
high speed III
Stop
9
2h
4h
Temps
A/M/
Publicité
Table des Matières
