Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
NOTE: Before assembly, insure that all parts and
quantities match parts list. Inspect all components
for shipping damage. If any parts are determined to
be missing or damaged, contact your dealer/retailer
for replacements.
WARNING!
DO NOT use this equipment without first
reading
and
understanding
sheet. If you are unable to understand these
instructions, contact a healthcare professional, dealer,
or technical person before installing. Otherwise,
injury or damage may occur. Use arms for assistance
only.
PARTS LIST:
1. Seat – 1 each
2. Leg – 4 each
3. Arms – 2 each
4. Back – 1 each
assembly instructions
1. Place seat (1) upside down on a flat surface.
Insert leg (2) into the corner recess of the seat
and rotate counter-clockwise until tight. Repeat
step #1 for all 4 legs.
2. For model with arms (3) place chair upright and
insert arms into holes in side of seat until arm is
fully engaged.
3. For models with a back (4) place back in the slot,
which is in the rear of the seat, and insert back
until engaged.
its
instruction
To adjust legs for proper height or uneven surfaces,
grab the bath bench leg with one hand while
rotating the bottom of the leg (where the suction
cup attaches to the leg) clockwise. The leg has an
adjustment window that indicates the level with a
red marker. Turn to desired height and repeat for
all legs.
4
3
Turn counter-clockwise
to install leg
Turn rubber tip clockwise
while holding leg tightly
to adjust leg height
disassembly instructions
1. The back has a lock tab that, when depressed,
will allow the back to be pulled out of their
slots freely.
2. To remove arms, pinch together the tabs on
the arm which, when assembled, will be under
the seat.
3. Turn the legs clockwise until removed from
bench.
care and maintenace
1. Do not use an abrasive cleaner. Use a non-
abrasive cleaner with warm water.
2. Periodically inspect all components for damage
or looseness.
1
2
Publicité
