Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION DIRECTORY
1. Usually our air compressor outlet is 1/8
BSP. If you want 1/4 BSP or other NPT
screw thread, you may need other adapt-
ers fix on the outlet. Then you can connect
with different air hoses.
2. The original air hose have rubber airproof
inside; the user can make the airtight by
hand, and get good performance. If the
air hose is not the original, usually the air
hose and air compressor cannot be well
airproof. However, 100% airtight is only
effective for auto stop function air com-
pressor. Teflon tape can be used to prevent
leakage. This elastic tape is available in all
stores selling sanitary products.
3. Connect the air compressor, air hose and
airbrush (or other air tools) plug into the
mains supply, turn on the switch, and then
the air compressor will start work. The
gauge will show the max pressure, and
you can adjust the working pressure by
adjusting the pressure adjustor.
4. Checking the air leakage. Please do not
use the air tools first, when the pressure
reach the max pressure (auto stop func-
tion), for the compressor do not have auto
stop function, please turn off the switch.
Then check the needle of pressure gauge,
if the needle on gauge is very steady, it
means the airtight is very good. If the nee-
dle decline down quickly, it means there is
air leakage in some place of connection.
Please check and make it airtight. Or any
small leakage will affect the performance
of the compressor. (It may lead to fre-
quently auto stop and auto start).
5. The difference between max pressure and
working pressure. A compressor s maxi-
All manuals and user guides at all-guides.com
mum pressure is the highest pressure it
can build up. When a connected airbrush
is opened, it is precisely with this pressure
that compressed air initially shoots out
through the airbrush nozzle. In contrast,
the working pressure is the constant pres-
sure the compressor can maintain dur-
ing airbrushing. The level of this working
pressure depends, on the other hand, the
nozzle diam eter of the airbrush to which
it is connected; the larger the nozzle diam-
eter, the greater the amount of air which
can escape and the lower the compressor
s working pressure.
6. The bottom of the regulator & filter is the
water release valve; users can open the
valve to release the water or moisture at
any time.
OPERATION OF REGULATOR
& FILTER
Characteristic
The HS-F2 is an in-line low pressure regula-
tor with a 100 p.s.i. gauge and moisture drain.
This regulator gives user control of operating
pressure as well as assisting in furnishing
clean, dry and regulated air. Regulators must
only be used as instructions and warnings
specify.
Operation
1. The gauge refect the working pressure of
the air tools.
2. Pull the top button up; turn clockwise to
increase the pressure; turn counter-clock-
wise to release the pressure.
3. Push the bottom needle to release the wa-
ter.
22 23
DISPOSAL
Appliances, accessories and packag-
ing must be recycled in an environ-
mentally responsible manner. Elec-
trical appliances which are not longer
serviceable can be returned to retailers for re-
cycling. Do not include electrical appliances in
domestic rubbish. As required by EU Directive
2002/96/EC on Waste Electrical and Electronic
Equipment as well as legislation enacting this
into national law, electrical equipment which
is no longer serviceable must be collected
separately and recycled in an environmentally
responsible manner.
Publicité
Table des Matières
