Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
GB

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 8) DURING THE MACHINE OPERATION PHASES:
During material loading;
During material mixing;
During the deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
Clean the mixing basket regularly to remove residues.
Check the mixing tool and the basket for wear.
The machine's reduction unit is lubricated with semi-fluid type synthetic grease suited for the lubrication of enclosed gears in casings.
When changing the grease, use only products with the characteristics listed below:
NLGI Degree:
Dropping point, °C
Thickening agent:
IN ORDER TO REPLACE THE LUBRICATING GREASE, CONTACT YOUR RETAILER.
DISPOSAL
In the event of scrapping the entire machine, it must be disposed of in accordance with the methods laid down by current
legislation.
Machine Frame
Electric Motor
Bucket
R.A.E.E. IT08020000002803
The European Directive 2012/19/EU arranges that in the event of scrapping of electrical equipment, they must not be
disposed of city solid refusals but collected separately, in order to optimize the level of recovery and recycling of the
materials and above all in order to prevent damages to health and environment. To comply with European Directive
2012/19/EU, all electrical equipments must be marked with crossed basket symbol. The packing of the machine will be
disposed of in accordance with the methods laid down by current legislation. For further information concerning disposal of
electrical equipment, please refer to public administration service.
18
0
115
SODIUM SOAPS
Polyamide
Steel
Aluminum
Battipav srl
Copper
Polyethylene

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

050s/aUsa050s/b

Table des Matières