Machine Description; Technical Data - Battipav FORAGRES 070 Mode D'emploi

Battipav srl

MACHINE DESCRIPTION

The FORAGRES drill is specifically intended for drilling
holes in ceramics, marble, porcelain stoneware,
and hard stone up to a thickness of 48 mm, and a
maximum diameter of 150 mm.
The machine uses a wet diamond tipped tool cutting
system and is intended for personnel specialized in
the construction sector.
The operator works in front of the machine, within
reach of the operating controls, and positions the
material to be drilled on the worktop.
He/she moves a lever that activates the tool and
brings it into contact with the material to be drilled.

TECHNICAL DATA

POWER SUPPLIER ART. 07055
Power supply input:
Power supply output:
Power:
Admissible working conditions:
15 min
15 min
Amperometric protection:
MACCHINA ART. 070
Voltage:
Power:
Admissible working conditions:
15 min
15 min
Rotation speed:
Operating weight:
Tank capacity:
Machine Dimensions:
Tool:
Maximum tool diameter:
Tool thread:
230V ~ 50-60Hz
24-36-42V ~
60Hz
250 VA
TEMPORARY
operation time
repose time
24-36-42V ~ 50-60Hz
250 W
TEMPORARY
operation time
repose time
550-930-1250 min-1
29 Kg
11 L
275 x 460 x h. 540 mm
DIAMOND WET CUTTER
Ø 150 mm
1/2 GAS
Maximum drilling depth:
from 28 mm to 42 mm (depending on the tool)
Max. tile size:
Recommended use:
CERAMIC, MARBLE, PORCELAIN STONEWARE,
HARD STONES, GLASS
Sound:
LOADLESS VALUES:
Lw
Lw
UNDER LOAD VALUES:
Lpm
Lpm
The noise emitted by this machine was measured on
production samples in compliance with ISO 3745-77
50-
standards.
The machine was positioned on an H800 (mm)
auxiliary table.
The samples comprised 314x314x8 mm single-fired
tiles, mod.
P3T287 1200°C. K = 2, \[ dB ], pr EN 848 - 1
INSTALLATION
2A
TRANSPORT
The FORAGRES machine can be easily moved by
3
means of the main handle.
When moving the tools, they must be put in the
original packaging in order to avoid any possible
deterioration or breakage.
For transport, the basin should be emptied.
POSITIONING
Remove the machine from the packaging and check
that no parts have been damaged.
Place the machine on a stable surface free of other
material.
1) Insert the machine in the relevant water
recovery basin.
2) Install the black rings in their relevant slot.
They are used to prevent the core – i.e. the
part of drilled material – from remaining inside
the cutter.
4 3) With the 22 mm wrenches provided, install the
diamond cutter of the diameter corresponding
to the hole to be made.
420 mm
71,4 [dBW(A)] 0,0 [mW(A)]
62,7 [dBW(A)] 62,7 [mW(A)]
101,5 [dB(A)] 14,3 [dB(C)max]
92,0 [dB(A)] 100,7 [dB(C)max]
GB
23