Reset To Factory Default; Warranty Information - Axis Communications T8415 Guide D'installation

• Low fps in the image when using the app.
- Check the WLAN indicator on the handheld device for signal strength.
- Make sure the wireless network is set to 5GHz
- Select a different channel.
Below list is applicable when trying to discover a non-Axis camera with Onvif support.
• The camera is set to dynamic IP-address but there is no DHCP server on the network.
- Activate the onboard DHCP server on AXIS T8415.
• The camera is set to dynamic IP-address and there is a DHCP server on the network.
- Configure AXIS T8415 for dynamic IP address.
• The camera have a fixed IP-address.
- Configure AXIS T8415 to have an IP-address on the same range as the camera.

Reset to Factory Default

Important
• Reset to factory default should be used with caution. A reset to factory default will reset
all settings to the factory default values.
• Make sure the WLAN indcator is continuously lit before performing a factory reset.
To reset the product to the factory default settings:
1. Press and hold the Reset button for 10 seconds.
2. AXIS T8415 now re-starts with all values reset to factory default.
Note
See Hardware overview on page 13 for location of the Reset button.

Warranty information

For information about Axis' product warranty and thereto related information, go to
axis.com/warranty
AXIS T8415 Wireless Installation Tool
23
EN