Remote Control - Beper VE.550 Manuel D'instructions

Air cooler Use Instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
INSTRUCTIONS FOR USE
Extract the product from the packaging and check the integrity of each component.
Place it on a flat, stable and heat-resistant surface.
Assemble the wheels using a screwdriver.
Note: Wheels with brake are for the front, while the wheels without brake are for the rear.
Pull out the water tank until it locks (approx. 10cm) and fill it with water. Observe the indicated MIN / MAX levels.
Note: It is recommended to frequently change water to avoid dirt and lime formation.
Insert the plug into the electrical socket, making sure it respects the parameters specified in the technical data.
Turn on the appliance with the button on the side, a slight beep is heard.

REMOTE CONTROL :

To activate the remote control, open the rear door and place the batteries (2 * AAA) in the correct polarity, close
the door. Follow the same procedure to replace the batteries when they are exhausted.
Buttons and Functions:
ON / OFF: allows you to turn on/off the appliance after plugging it in the socket.
SPEED: allows you to selects the desired ventilation speed LOW→MID→HIGH, also displayed as 1-2-3. When
you turn on the appliance for the first time, it will automatically be positioned for approx. 3 seconds to MID posi-
tion, then move to LOW position.
MODE: allows you to select the mode of operation NATURE à SLEEPàNORMAL
SWING: allows to adjust / lock the swing of the inner louvers (right / left movement). The outer louvers are adju-
stable from top to bottom in a manual way.
COOL: allows you to activate the cooler function.
IONIZER: Enables the ionization function (releases negative ions that purify the air).
TIMER: allows you to activate and set the timer from 1 to 24 hours.
HUMIDIFIER: allows you to activate the humidifier in order to increase humidity of the air.
8