Important - BST CDD 250 FX Mode D'emploi

ENGLISH
CAUTION
To prevent electric shock do not remove cover (or bottom) screws.
No user serviceable parts inside refer servicing to qualified
servicing personnel.

IMPORTANT

Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
DESCRIPTION
Dual CD player with jog wheels
Front Panel :
1. DISC HOLDER
2. POWER SWITCH ( ON / OFF )
Press the power switch to turn the unit on. To switch the
POWER off press the POWER switch again.
3. OPEN / CLOSE BUTTON
Press to load or eject disk. Each press will open or close the
disk tray.
NOTE: disc holder will not open unless stop or pause button
has been pushed first.
4. WHEELS
The wheels have two functions :
- During the playback, it work like the pitch bend buttons.
- In pause mode, you can make a frame by frame
search.
5. BOP BUTTON
The bop button have the same function like the cue button.
Just the playback don't stop when you press the button. The
playback will continu from the cue point.
6. CUE BUTTON
The cue button is used to recall the last cue point.
All manuals and user guides at all-guides.com
4
One press on this button : the plaback stops and the cd player
recall the last cue point. If you press the play/pause button,
the playback will start from this point.
To set a cue point : Press the play/pause button to enter in
the pause mode and press the cue point to set the point you
want.
7. PLAY/PAUSE BUTTON
Each press of the button to change from play to pause or from
pause to play.
8. SEAMLESS LOOP
These three buttons In, B(loop)/exit & reloop allows you to
make a seamless loop
The In button sets the starting point of the llop
-
The Out(loop)/exit button sets the ending point of the
-
loop and start the playback of the loop
Reloop button : This button is used to recall the loop
-
you make before. Press the out(loop)/exit button to stop
the loop.
9. BPM BUTTON
The TAP button is used for manual BPM.
10. PITCH POTENTIOMETER
This slider is used to adjust the playback pitch percentage.
The slider is a set adjustment and will remain set until the
pitch slider is move or the pitch function has been turned off.
11. PITCH BEND
This two buttons increase or decrease the speed of the track
The pitch of CD decreases while the - button is pressing and
returns to the original pitch when the button is releases.
The pitch of CD increases while the + button is pressing and
returns to the original pitch when the button is releases.
12. PITCH BUTTON
This button is used to turn the PITCH SLIDER function on and
off.
13. TIME/STOP BUTTON
The TIME button will switch the time value described in the
time meter between elapsed play time, track remaining time,
and total remaining time. If you hold this button during more
3s, the cd player enter in the stop mode.
14. CONTINU/SINGLE BUTTON
This function allows you to choose between single track play
or continuous track play (all tracks in order). Autocue function
avoid the blank part in the beginning of the track
15. SKIP FORWARD BUTTON
Used this knob to select the next track