Little Seeds 4559409LS Mode D'emploi page 12

Step 2
Attach E to C and D with
Screw , to C and D.
2.1 The mattress support has three adjustable positions.
Loosen the bolt
Make sure you install all of the bolts
unused adjustable position holes.
2.2 Rotate the bracket to proper
position as illustrated and attach
to POST with
NOTE: Tabs must always be above the
mattress support when installed as shown in
right picture.
Do not install the mattress support up side down
where the 4 edges are above the wire mesh.
C
www.littleseedskids.com
, .
, and adjust the mattress support level.
,
, .
E
2.3 Please ensure the
label "THIS SIDE UP"
facing upwards.
2.4 Do not remove this
pouch from there!
in any of the
D
NOTE: Please ensure that all the height
adjustment holes are filled with appropriate bolts
after the mattress support has been removed to
the desired level. Make sure that these bolts are
tightly secured. Number of mattress support
position depends on crib's model.
12
5
5
5
E
2.5 Tabs on corners of
mattress support should
point up.
5
4
X 12
4
4
3
3
X 8 X 4