Connecting To Power; Power Supply - Roadstar CDR-7000U Manuel D'instructions

LITHIUM BATTERY INSTALLATION OF REMOTE CONTROL
l The remote control includes one CR2025(3V) lithium battery.
l To replace the battery, gently push the clasp to the right direction
accordingly to the instruction and then pull out the battery compartment.
Take the drained battery out and install a new lithium battery (CR-2025)
in the compartment with the positive polarity upward. Then push the
compartment back to its position with a "click" sound indicating installation
finished

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this
unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other power
sources may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.

POWER SUPPLY

Remove the stereo carefully from the box, retaining the packaging for future use.
AC POWER OPERATION
English 5
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
MAIN UNIT BATTERY POWER
To install batteries:
Switching On the Unit
l After connecting the power, the display will show AM 0:00. Remain this mode , the unit
l ESD hints-The product maybe reset or not reset to operation of control due to
l Setting the Time
Note: Please make sure that all connections have been ready.
1. In standby mode the LCD display will flash 0:00. Press the SET/ID3 button, the display will
2. After confirm the hours system, the Hour digits will flash, press the or button on unit or on
Waking up the music (Radio/CD/USB)
You can set the timer to wake up the Radio, CD/MP3 or USB.
1. After setting the time in standby mode, press and hold the TIMER button on unit or press
2. Enter the desired hour with the or button, press the TIMER button on unit or on remote
6 English
• Open the battery compartment (on the back of the panel) by pushing down on the two
tabs at the upper edge of the compartment cover. Pull the cover away from the back
panel.
would turn of automatically after 15 minutes. Press STANDBY button to turn on the unit
and press STANDBY button again to play.
electrostatic discharge, just switch off and reconnect again.
show the RTC 12 hours or the RTC 24 hours version. Press SKIP UP
on unit or on remote to choose for the 12 or 24 hour version. Press the SET/ID3 button to
confirm.
remote repeatedly to set the clock to the correct Hour, press the SET/ID3 button to confirm.
Then the minute digits will flash, press the or button on unit on remote repeatedly to set
the clock to the correct Minutes, press the SET/ID3 button again to confirm.
TIMER key on remote control to set the desired wake up time.
control to confirm. Enter the desired minutes with the or button, press the TIMER button
on unit or on remote control to confirm. Then choose the desired wake up mode (RADIO/
CD/USB) by or button and press TIMER button on unit or on remote control to confirm.
/DOWN button