Adjusting Salt Consumption; Adding Detergent - Koenic KDW 1112 Mode D'emploi

Size - A5
English
Note:
Depending on how fully the salt dissolves,
the salt warning light may still be on even
though the salt container is filled.
Warning
• Only use salt specifically designed for
use in dishwashers! All other types of
salt not specifically designed for use in
a dishwasher, especially table salt, will
damage the water softener. In case of
damages caused by the use of unsuitable
salt the manufacturer does not give any
warranty nor is he liable for any caused
damages.
• If there are spills of the salt, a soak or a
rapid program should be run to remove
the excess salt.
• Only fill with salt just before starting
one of the complete washing programs.
This will prevent any grains of salt or
salty water, which may have been spilt,
remaining at the bottom of the machine
for any period of time, which may cause
corrosion.
• The salt container must only be refilled
when the salt warning light in the control
panel comes on.

Adjusting salt consumption

Activate the setup mode: The
Fig.
6
setting mode must be activated within
60 seconds after switching the product
on and with the door closed. Press
Start/Pause button and hold for 5
seconds, the machine will enter the
setup mode which is indicated by the
blinking preset salt setting HX (default:
H3).
Adjust level of salt consumption:
Press the Start/Pause button to
select the proper setting according to
your local environment. Follow table
below to find correct setting.
20
IM_KDW1112_180620_V05_HR.indb 20
All manuals and user guides at all-guides.com
Water Hardness level
°dH mmol/l
1)
0-5 0-0.94
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.0
35-55 6.1-9.8
The product will exit the setup mode
automatically 5 seconds after the last
setting/operation.
Note:
German degree of measurement for the
1)
water hardness
Millimol, international unit for water hardness
2)
Factory setting
*)
Contact your local water board for
information on the hardness of your water
supply.

Adding detergent

Fig. The dispenser must be refilled before
7
the start of each wash cycle.
For the correct amount follow the
instructions provided with the
detergent.
• Always add the detergent powder
just before starting each wash cycle,
otherwise it could get damp and will
not dissolve properly.
Note:
Only use detergent specifically made for use
in dishwashers. Keep your detergent fresh and
dry.
Setting
2)
H1
H2
H3*
H4
H5
H6
20/6/18 2:05 pm