Middle Atlantic Products FC-4A Mode D'emploi page 7

CONNECTING MODULES
NOTE:
• Additional modules (not provided) may be daisy-chained together as explained in this topic.
• Generic modules are shown and may not excactly match specific products.
WARNING: Do not connect or disconnect the product while under
load.
AVERTISSEMENT: Ne connectez pas et ne débranchez pas le
produit lorsqu'il est sous charge.
1. Interconnect module with our genderless J (jumper) or T (tail) series
connector assembly (Model Nos. J-xX6 and T-xX6, not provided).
NOTE: Interlock J or T series connector assemblies
before common connector attachment. (FIGURE B)
2. Connect the interlocked J or T series connector assembly to either
common connector (top or bottom connector row).
FIGURE C
NOTE: Additinoal modules are not provided
and are shown only for reference.
INSTALLING MODULES INTO YOUR MPR RACEWAY
NOTE:
• All module ground wires must be connected to the facility ground and bonded to the ground stud in the
J-Box.
• Generic modules are shown and may not excactly match specific products.
1. Carefully insert the module into your raceway as shown. (FIGURE D)
M-PCON-20A
120V/240V - 20A - 60Hz
Conforms to UL Std
5 & 5A
Certified to CSA Std
C22.2 No. 62 & C22.2 No. 62. 1
FIGURE E
20 AMP MODULE
2. Slide the module into place
on your raceway and then
DO NOT CONNECT
position as desired.
OR DISCONNECT
UNDER LOAD
(FIGURE E)
Interlock the J or T series
connector assemblies before
attachment.
TIP: For easy cable management, connect the cables
on multiple modules as shown. (FIGURE C)
3. Install the module into your MPR raceway as
explained in the following topic.
Page 7
J or T Series
Common
Connector
Connector
Assembly
(Top and Bottom Rows)
(Not Provided)
FIGURE B
FIGURE D