Installing The Fan Unit; Installing The Internal Panel - Steibel Eltron LWE 40 Installation

INsTALLATIoN
Installation
Note
The existing cable between the adaptor board and the
programming unit must not be extended.
f Screw the plate frame onto the flush box. The tabs must be f
facing up and down.
f Position the cover frame on the plate frame. f
f Place the programming unit in the cover frame aperture. f
Carefully push the programming unit until it clicks into place
in the plate frame.
5.4

Installing the fan unit

f Remove the support elements from the wall mount casing. f
f Clean the wall mount casing. f
f Push the fan unit into the wall mount casing so that the f
bracket is inside at the bottom.
f Ensure that the fan unit does not get wedged or get hooked f
on the wall mount casing.
f Push the fan unit as far as it will go into the wall mount f
casing.
www.stiebel-eltron.com
f Plug the fan unit plug into the plug-in connection. f
f Click the plug into place. f
5.5

Installing the internal panel

Standard internal panel
f If the internal panel is not open, carefully pull the internal f
panel cover slightly back from the base plate.
f Rotate the internal panel cover 45° anti-clockwise. f
f Remove the cover. f
LWE 40 | 33