Boston Classic CS 23 10 Manuel Du Propriétaire page 5

Line level or LFE: On most systems use the line level in or the LFE input. These inputs accept the line-level signal from your
receiver's subwoofer output. Your receiver's manual should indicate which input is most appropriate.
Turn off all power. Use the subwoofer cable included with your system to connect the subwoofer to your receiver's
Subwoofer or LFE output. Connect the other end to the "Line In" on the back of the Subwoofer.
Connecting the Subwoofer to Digital Home Theater Systems Using LFE
Digital 5.1, 6.1 and 7.1 home theater electronics dedicate one channel (the ".1") to reproduce the special low-frequency (LFE)
information (such as explosions and thunder) contained in digitally-encoded soundtracks.
Select "subwoofer-yes" from your receiver's set-up menu. Hooked up this way, the receiver's amplifier is
to reproduce the difficult low bass signals that can drive the receiver into audible distortion. In some cases, it can also depend
on several other settings within a receiver. We recommend consulting your receiver manual for further assistance in this area.
Use the subwoofer cable, as shown, to connect your digital receiver's LFE subwoofer output to the subwoofer. Connect the
other end to the LFE input.
digital receiver
Connecting the Subwoofer to Stereo or Dolby® Pro Logic®
For stereo or Dolby Pro Logic systems use the "sub out" connection from your receiver to the input on the subwoofer marked
"Left" and "Right".
receiver
Connecting to Electronics Without a Subwoofer Output
If the electronic in your system does not have a subwoofer of LFE output you can connect the CS Sub 10 to a preamp output.
Use a stereo RCA cable (not included) to connect the preamp outputs to the Left and Right Line Level inputs.
receiver
All manuals and user guides at all-guides.com
use either input
Preamp Out
relieved of having
.
CS Sub10 Ampli er
CS Sub10 Ampli er
CS Sub10 Ampli er
E
N
G
L
I
S
H
5