Power Off; Reading Safety Notice - CaterChef 450.100 Serie Mode D'emploi

Operating instructions
Caution
◆
Do not put the machine close to heat source, especially hot stove or high temperature appliance,
otherwise it is likely to make the machine
◆
Before using, please place the machine on a clean, strong horizontal table, to prevent the machine
sliding.
◆
Do not put the machine on the edge of the table, and do not use in unattended state.
◆T
mixing bowl, mixing bowl lid, steamer, steamer lid and measuring cup are with high temperature
during cooking do not touch to avoid burns.
Power on
◆
Before use, please pull out the power cord on the right side of machine with appropriate length.
◆
In principle, the length is with what the plug insert into the socket and the power cord is not tight is
advisable.
◆
The power cord should not be stretched out too long, so as to avoid winding , but if too short and
too tight may affect the accuracy of weighing function.
◆
After the host is connected to the power supply, press knob to start the machine. The screen will
display as shown in figure 1.
Conten s page/Main menu function
Time icon
Flour
Scale function
10
fire.
Temperature icon
①
Main menu page

Power off

◆
In the operation state, long press the knob until the
display shows "Stop the current operation,
ready to power off", as shown in Figure 2, then
click "Enter" to turn off, or click "Cancel" to
return to the
◆In the
state, long press the knob until the
screen display " Power off...", as shown in Figure
3, then click "Enter" to turn off, or click "Cancel" to
return the original state.

Reading safety notice

◆On the boot page, click on "Read" to read the
contents of the safety notice, if read, click "have
read" directly into the home page, as shown in
figure 4.
◆Click on the "Read" into the contents of safety
notice, it can be read by clicking on the "
or " " until the last page click on " Have
read" exit the safety notice and go to the main
page as shown in figure 5.
Speed icon
TopSpeed
◆On the main page as shown in Figure 6, you can
click the icon on display to set the time,
temperature and speed, after selection, rotate the
Reversal function
knob to adjust time, temperature and speed
parameters.
state.
"
②
③
④
⑤
11