AquaScape DE-ICER Instructions Et Entretien page 4

USING THE POND DE-ICER WITH
AN AQUASCAPE AERATION SYSTEM
PLEASE NOTE: If you are also using an
Aquascape aeration system in addition to the
Aquascape 300-Watt Pond De-Icer, place the
aerator or air stone beneath the De-Icer to increase the
degassing effect.
TROUBLESHOOTING
In the event that the Aquascape 300-Watt Pond
De-Icer should malfunction or fail to operate, please
check the following:
• Check to ensure that the unit is plugged in properly
• Make sure that the GFI-rated receptacle or ground fault
interrupter is operating properly
• Check to see that the LED light on the top of the unit is
indicating that the unit is heating. LED light will be red
when unit is heating. If the indicator LED light on top of the
unit is blue, the heater is in the off mode and not heating.
The LED indicator light and thermostat is a safety function
of the heater to prevent accidental burns. If not functioning
correctly you may need to reset the thermostat by
unplugging the heater, for approximately one hour, to allow
the heater to completely cool. When you plug in the heater
the LED indicator should turn red, indicating heating.
For more information about our company or products, please visit our website at www.aquascapeinc.com
39000.062013
4
or call us at (US) 1-866-877-6637 (CAN) 1-866-766-3426
©2013 Aquascape, Inc. • All Worldwide Rights Reserved
☎
US 1-866-877-6637 |
PLEASE NOTE: The thermostat on the heater
is set to turn off at 70°F or 21°C, the thermostat
or safety shut off is a safety feature and not
meant to turn off the heater when ice is not present.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com