ONFORU D50 Manuel Du Produit page 2

SAFETY INFORMATION / SICHERHEITSINFORMATIONEN / INOFRMATION DE
SÉCURITÉ / LA INFORMACIÓN DE SEGURIDAD / INFORMAZIONI SULLA SICUREZZA
Disconnect the power supply before attempting any work on the unit！
EN
Installing these units involves work on the mains voltage supply; installation must therefore
be carried out professionally in accordance with the appliance national wiring regulations
and electrical operating conditions.
The product must be installed by a licensed professional electrician.
Check all components for damage, do not use the product if it is damaged.
To ensure the product can work normally, please use it in the voltage within the range on
the lamp label.
The floodlight enclosure heats up when the light is on.Please adjust the angle of the light
after the power off for 10-15 minutes. Do not look into the LED light at a short range
or any prolonged period(>5 min).
Do not install the unit on (normally) flammable surfaces.
Do not alter or change parts of the light at will, in case of the accidents such as breakage,
fall, electric shock, fire, etc.
Only to be installed outside arm's reach
The light is IP66 waterproof, but the plug is non-waterproof. Please connect the plug indoor or
connect to a socket that provides IP65 protection.
Please use tools to adjust the lights.
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
Never plug the light in with wet hands in case of electric shock.
This light is a non-dimmable product. To avoid failure, please don't connect it with the dimming
controller.
Do not connect this light fixture to an ungrounded electrical system.
WARNING: Installing this light in an ungrounded electrical system may cause the metal parts of
the light to carry current if any wires or wire connections are damaged or loose. In this case,
anyone who touches the light will receive an electric shock, resulting in injury or death.
Be sure to use wire nuts/connectors rated for the correct gauge and number of wires used.
NOTE: Make sure there are no exposed wire bundles outside the wire nut/connector
(if applicable).
Be careful not to damage or cut the wire insulation (covering) during installation. Do not let the
wires touch any sharp edges.
The floodlight is supplied with cable and must be terminated using a terminal block (not supplied)
in a suitable IP rated enclosure (not included).
For type Z attachments：
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is
damaged, the luminaire shall be destroyed.