Introduction; Package Contents; Product Features; Stand-Alone Installation - Tripp-Lite B114-002-R Manuel De L'utilisateur

Introduction

The Video Splitter is a signal booster and splitter that takes video input from a single source
and directs it to multiple video outputs for monitors using analog signals. It extends the distance
a signal is sent up to 210 ft.

Package Contents

• B114-002-R or B114-004-R
• External Power Supply (Input: 100-240V, 50/60Hz, 0.4A Output: 9V 1A)
• Owner's Manual

Product Features

• One video input to multiple video outputs
• Transmission distance of up to 210 feet
• Suitable for VGA/SVGA/XGA/UXGA and Multisync monitors
• Cascade up to 3 levels of splitters to increase the number of outputs
• Supports 350 MHz bandwidth
IMPORTANT NOTE: This unit is not designed for CGA, EGA or MONOCHROME type
monitors or any monitor using a digital video signal.
Installation

Stand-Alone Installation:

1. Connect the PC's video output port to the Video Splitter's "Video In" port using an HDDB15
Male/Female Monitor Extension Cable (such as Tripp Lite's P500-Series Cables).
2. Connect the Video Splitter's "Video Out" ports to the input of your monitors either by using the
existing cable on the monitor or by using an HDDB15 Male/Male Monitor Cable
(such as Tripp Lite's P502-Series Cables).
3. Connect the provided power supply to the Video Splitter and turn on the unit. Your Video
Splitter is ready to go.
Use ONLY the 9V DC external power supply included with the unit.
WARNING!
2