Johnson Controls M9310 Serie Notice D'installation page 3

Adjusting the Angular Rotation Stops
Figure 5: Lifting the Tab
Figure 6: Removing Coupler
Figure 7: Rotating Coupler
M9310 Series Electric Non-Spring Return Actuators Installation Instructions
Figure 8: Installing Coupler
Mounting the Actuator
1. Position the damper until it is fully closed. See
Table 2 for shaft diameters and required torques.
Figure 9: Mounting the Actuator
2. Bend or cut the anti-rotation bracket to fit the
damper frame or duct.
Slot for Bracket
M3.5 Screws (2)
Anti-Rotation Bracket
Damper
Frame
Figure 10: Forming the Mounting Bracket
3. Load the actuator seal by rotating the shaft using
the actuator (about 5 degrees).
3
Anti-Rotation
Bracket Tab