Buyers ATVS100 Instructions D'installation page 2

INSERT THIS END OF
CONTROL ROD INTO
THE RESTRICTOR
PLATE, THEN INSERT
OTHER END INTO
CONTROL HANDLE
FASTEN MOTOR ASSEMBLY TO
THE HOPPER (4x M6x20)
INSERT COTTER PIN THROUGH HOLE IN
SPINNER DISC AND MOTOR SHAFT
fig. 1
USE FLAT WASHERS
WITH M6 LOCKING
NUTS TO SECURE
MOTOR ASSEMBLY
TO HOPPER
GROMMET ON MOTOR WIRE
MUST BE INSERTED INTO THIS
HOLE TO PREVENT MATERIAL
FROM FALLING OUT