D-Link DUB-1340 Guide D'installation Rapide page 4

Concentrateur chargeur usb 3.0 superspeed à 4 ports
Masquer les pouces Voir aussi pour DUB-1340:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connect the power adapter to the
1
power connector on the back of the
DUB-1340, then plug the power adapter
into a power outlet.
Connect the included USB 3.0 cable
2
to the connector on the back of the
DUB-1340.
Connect the other end to the USB 3.0
3
port on your computer.
Alternatively, you may use a USB 2.0
Standard-A to USB 2.0 Micro-B cable to
connect the hub to your computer. In
this case, you will only be able to use
the DUB-1340 as a USB 2.0 hub.
You may now connect your USB devices to the hub. It is recommended
4
to connect them one at a time and allow your computer to recognize
the device.
Note: Please make sure that the power draw requirements for devices connected to the DUB-1340 do not
exceed 2.4 A for a single port, or 3.2 A total for all connected devices.
Installation
4

Publicité

Table des Matières
loading

Table des Matières