Installation Steps; Package Contents - Axis Communications M7001 Guide D'installation

AXIS M7001 Installation Guide
AXIS M7001 Video Encoder
This installation guide provides instructions for installing a AXIS M7001 Video Encoder on your
network. For all other aspects of using the product, please see the product User's Manual, available
on the CD included in this package, or from www.axis.com

Installation steps

Follow these steps to install the AXIS M7001 Video Encoder on your local network (LAN):
1. Check the package contents against the list below.
2. Hardware overview. See page page 6.
3. Install the hardware. See page 7.
4. Assign an IP address. See page 8.
5. Set the password. See page 11.

Package contents

Item
Video encoder
Mounting kit
CD
Printed materials
If a covert camera was purchased together with the AXIS M7001 Video Encoder, the package
should also contain:
Item
Covert camera
Mounting kit
See Covert camera, on page 17 for more information.
Installation Guide
Models/variants/notes
AXIS M7001
• Metal bracket for wall/ceiling mounting
• 2 screws and plugs for concrete walls
• Terminal block connector (RS-485/422: 2x 2-pin connector)
Installation and Management Software CD
AXIS M7001 Installation Guide (this document)
Models/variants/notes
Analog camera
• Metal bracket for wall/ceiling mounting
• 2 screws and plugs for concrete walls
Important!
This product must be used in
compliance with local laws and
regulations.
Page 5