Acson international A5WMY10KR Mode D'emploi page 24

01_EN_3P257186-2A.fm Page 23 Saturday, October 31, 2009 2:19 PM
The outdoor unit emits water or
steam.
■ In HEAT operation
• The frost on the outdoor unit melts into water
or steam when the air conditioner is in
defrost operation.
■ In COOL or DRY operation
• Moisture in the air condenses into water on
the cool surface of outdoor unit piping and
drips.
The air conditioner does not
operate.
(OPERATION lamp is off.)
• Hasn't a breaker turned off or a fuse blown?
• Isn't it a power failure?
• Are batteries set in the remote controller?
• Is the timer setting correct?
Hot air does not flow out soon after
the start of HEAT operation.
• The air conditioner is warming up.
You should wait for 1 to 4 minutes.
(The system is designed to start discharging
air only after it has reached a certain
temperature.)
Operation stopped suddenly.
(OPERATION lamp flashes.)
• Are the air filters clean?
• Is there anything to block the air inlet or the
outlet of the indoor and the outdoor units?
• Clean the air filters or take all obstacles away
and turn the breaker off. Then turn it on
again and try operating the air conditioner
with the remote controller. If the lamp still
flashes, call the service shop where you
bought the air conditioner.
Operation stopped suddenly.
(OPERATION lamp is on.)
• For system protection, the air conditioner
may stop operating on a sudden large
voltage fluctuation. It automatically resumes
operation in about 3 minutes.
Mist comes out of the indoor unit.
• This happens when the air in the room is
cooled into mist by the cold airflow during
COOL operation.
• This is because the air in the room is cooled
by the heat exchanger and becomes mist
during defrost operation.
23