Inspection; Battery Parameters; Preparation; Battery Connection - Creabest LiFePO4 Manuel D'installation

3.2 Inspection

After receiving the LiFePo4 battery, please check carefully whether the battery has been
damaged by any means (such as transportation). In this case, please do not put the battery into
use and contact the seller.

3.3 Battery parameters

Total Energy
Standard Discharge Current
Peak Discharge Current(1s)
Standard Charge Current
Recommended Charge
BMS low voltage protection

3.4 Preparation

Before installing and operating the battery, it is recommended to prepare the following
equipment or tools:
Correct protective equipment

Isolation tool

Multimeter

AWG3/30mm2 or thicker wire (black and red)

Suitable charger/charge controller/charging system

Wire cutter

M8 screwdriver

Insulation tape


3.5 Battery connection

According to the distance between inverter and battery pack, to prepare the length of the

wire, and each terminal copper should be 11-14mm,see below：
DE Web: https://www.creabest.de/
Voltage
172Ah
Capacity
2200Wh
30A-60A
14.4V-
Voltage
≤15mΩ
Resistance
LiFePO4
Cell Type
11 -14
mm
FR Web: https://www.creabest.fr/
12.8V
Discharge Temperature
Charge Temperature
Storage Temperature
200A
Terminal Type
600A
Communication
Communication Terminal
Dimensions
14.6V
8V
Net Weight
Outside Dimensions
Gross Weight
6
-20℃-60℃
0℃-55℃
-20℃-60℃
M8
RS232
Not Open
357x338x152mm
26.7KG
450x450x255mm
29KG
IT Web: https://creabest.it/