Light-N-Carry LNC375 Mode D'emploi page 5

CHARGING
NOTE: CHARGE THE TORCH LIGHT IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE, AND AT LEAST
EVERY 3 MONTHS WHEN NOT IN USE. Failure to do this
will reduce the battery's useful life.
Charging Direct via USB Port
• Turn the collar below the head of the light counter clockwise to
reveal microUSB input.
• Connect the microUSB end of the charging cable to the
microUSB port on the torch light. Connect the USB end of the
charging cable to the USB port of a common 5V AC charger.
• The Charging Status LED will illuminate red to indicate unit
is charging. To reach full charge, continue charging until the
Charge Status LED turns green.
Charging via Wireless Charging Base
• Connect the micro USB into the port on the charge base.
Connect the USB to the provided 5V 2A adapter. The Blue
LED ring on the charge base will illuminate when connected.
• Place the light into the charge base and wireless charging will
automatically begin. The LED ring on the light will illuminate
red when charging, and green when full.
Charging will take approximately 5 hours, depending on the
unit's state of charge at the start of the cycle.
The charging process is fully automatic and the light can remain
connected to the charger indefinitely without adverse conse-
quences.
5