Hkoenig plx830 Manuel D'instructions page 10

and operating instructions. Check the cylinder to regulator connection and hose to plancha
hose inlet connection for leakage using soapy water. Any leakage will show as bubbles in the
area of the leak. If leak is found, do not use the plancha. Consult your gas or plancha supplier
for advice.
4. To light the left hand burner, push down and turn the left burner control knob anti-clockwise
to the 90° position (full rate position). An audible click will be heard, this should light the
burner. Check that the burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before
retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
7. Light the remaining burners from left to right in sequence.
8. To turn 'OFF' the plancha, turn the cylinder valve handle or regulator switch to the 'OFF'
position by following the regulator instructions. Once the burners have extinguished turn all
the control knobs to the 'OFF' position.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or turning 'OFF'
the cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve and
regulator switch to the 'OFF' position. Wait 5 minutes before attempting to relight the appliance. If
the problem persists after relighting, consult your gas dealer, or the store where you purchased the
plancha, or a qualified gas engineer for assistance or repair. Never try to rectify the problem yourself
as this could result in serious injury and/or property damage.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent solution
as the cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight.
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas and fitted with the
appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator
and the appliance with hose clips/nuts. This plancha is set to operate a 28 mbar regulator with
butane gas, and a 37mbar regulator with propane gas, and a regulator with butane/propane mixture
at 37mbar, and a regulator with butane/propane mixture at 50mbar and a regulator with
butane/propane mixture at 30mbar. Use a suitable regulator certified to BSEN 16129: 2013. Please
consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
Never check for leaks with a naked flame, always use a soapy water solution.
TO CHECK FOR LEAKS
BEFORE USE PLEASE CHECK FOR LEAKAGE!