Whale WHGT0810B Guide Rapide

To the Fitter
Ensure all relevant personnel read the points listed
below before servicing this product.
To the User
Read the points listed below before installation and
use of equipment.
Application & Specification
The Grey Waste Tank is designed to collect waste
water from shower trays and sinks, then automatical-
ly trigger a suitably attached sump pump to empty the
tank (we recommend the Gulper 320, BP2052 (12V)
or BP2054 (24V).
If it is intended for use for any other purpose or with
any other liquid, it is the users' responsibility to ensure
that the tank is suitable for the intended use and, in
particular, that the materials are fully compatible with
the liquids to be used.
The Grey Waste Tank has 8 inlet ports of various
outer
diameters (detailed in Fig. 3).
Waste water enters the tank through these inlets from
shower trays and sinks etc and as the water level
rises, reaching a sufficient level, the switch is
activated, causing the sump pump to operate and
empty the tank.
The Grey Waste Tank is made from medium density
polyethylene and holds 8.5 litres (2.15 US gals) of
water when full. It comes with a 6" diameter (152 mm)
clear inspection hatch allowing easy access for
cleaning and maintenance.
Installation
Incorrect wiring may cause permanent damage.
N.B. This switch is polarity sensitive (see Fig. 6).
The switch to activate the pump is attached to the lid.
This switch operates using field effect sensor and
contains no moving parts or mercury.
Provision has been included on both sides of the grey
waste tank to allow a Gulper pump to be mounted
(see Fig. 4 & 5). Five mounting screws & washers are
included which screw into the inserts in the sides of
the tank (see Fig. 5).
The preferred method of discharge through the hull is
above the waterline. Where this is not possible a
vented loop must be used.
Grey Waste Tank
Installation cont.
The tank can be mounted either horizontally or at an
angle not more than 10º to the horizontal. Four
mounting screws are provided - these are screwed
down, with the supplied washers, via the four feet of
the tank to secure the system in position.
The tank comes with three different inlet port sizes,
(see table overleaf). The inlets are opened by drilling
a hole using the pilot mark for guidance (see Fig.1).
The drilling options listed in table 1 overleaf give the
recommended drill sizes to use. After drilling the holes
in the ports, ensure swarf is removed from inside the
tank.
Check that all hosing connected to the system is
tightly secured (we recommend using two hose
clamps per port) and that no leaks occur. For typical
installation see Fig.2.
Maintenance
As a helpful hint we recommend flushing out the
system every six months to clear the tank of debris.
Warranty
Whale Grey Waste Tanks are guaranteed for 1 year
against defects in materials and workmanship.
For warranty details please refer to the enclosed copy
of Whale's Statement of Limited Warranty.
©Copyright Whale 2011- All rights reserved.
WHALE®, is a registered trademark of Munster
Simms Engineering Limited, Bangor Northern Ireland
trading as Whale. Whale's policy is one of continuous
improvement and we reserve the right to change
specifications without prior notice. Illustrations are
for guidance purposes only.
Fig 1