Troubleshooting - Mvision ST-5 USB Mode D'emploi

MENU GUIDE
VI.Utility
VI-4. USB PVR
Connect your USB memory device to STB
1. Record
∙IF you want to record the program, Press "REC"button.
∙Press "STOP" button to stop recording.
2.PLAY
∙If you want to play the recorded file in your USB
memory device, press "PLAY" button and then File List will be displayed.
∙Select the file which you want to play using ▲▼and press OK.
∙If you want play other file, press OK button and File List will be displayed
∙SLOW : Press "PLAY" button. If you press "PLAY" button again, the speed will be normal.
∙F/F, Rewind, Pause is supported.
3. File Manager (Go to Main Menu Utility USB)
∙Delete
- If you want to delete the file, press Yellow button.
- Select the file which you want to delete using ▲▼ and press OK.
∙Fromat
- The STB supports only FAT32 file system
- If you want to format your memory device onto FAT32, press Blue button.
- After format, the all data will be deleted.
4. Caution
∙The only USB 2.0 high speed device is supported for PVR function.
∙S / W download and MP3 play supports USB 1.1 full speed.
∙Plesae use more than 2GByte memory device or USB HDD for PVR function.
∙Normally 1GBtye can record 30~40 minutes depends on program.
∙Some USB memory device cannot be supported.
∙Memory fragmentation can occur record problem, please format your USB memory device
ossasionally.
∙For more information and updated software, please visit our website.
22

TROUBLESHOOTING

Problem
Nothing appears on the Front
∙Check that the power cable is plugged into the power
Panel or No power supply
socket.
∙Check the dish and adjust it.
∙Check the cable connection and correct it.
No Picture
∙Get out of UHF mode.
∙Check channel and video output.
∙Check the volume level of the TV and receiver.
∙Check the mute status of TV and receiver.
No Sound
∙Check the cable connection and correct.
∙Replace batteries.
Remote Control Unit dose not
∙Aim the remote control unit directly to the receiver.
work
∙Checking that nothing blocks the front panel.
∙Check the Conditional Access Module and smart card are
appropriate for the selected service.
Service is not running or
scrambled ∙Check the Conditional Access Module and smart card are
correctly inserted or not.
∙Check the signal strength and the signal quality in the
menu.
∙Check the LNB and replace the LNB if necessary.
"No Signal" on the screen
∙Check the LNB cable.
∙Check the Dish and adjust it.
Tuner Defective Check
∙Go to the Option and select System Information.
You have forgotten your
∙Contact your Service Provider.
secret PIN Code
Solution
23