Finishing The Installation - Hinkley 56 GROVE Manuel Du Propriétaire

FINISHING THE INSTALLATION

1 Tuck connections neatly into ceiling outlet box.
Slide the canopy up to mounting bracket and place the
2
key hole on the canopy over the screw on the mounting
bracket, turn canopy until it locks in place at the narrow
section of the key holes.
Align the circular hole on canopy with the remaining
3
hole on the mounting bracket, secure by tightening the
two set screws.
NOTE: Adjust the canopy screws as necessary until the
canopy and trim ring are snug.
WARNING:
Make sure the hook on the hanging bracket properly
sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the
housing until it drops into place.
INSTALLING THE LED LIGHT BULBS
Install the 3 led bulbs (included) in the sockets located
1
in the top of the motor housing.
Ceiling Fan
Outlet Box
Hanger
Bracket
Canopy
Trim Ring
Bulbs
©2019 Hinkley Lighting, Inc. | hinkley.com |
Groove
Screws
Motor
09