Adler europe AD 2104 Mode D'emploi page 4

immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified electrician
before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the unit on to the wall outlet or power supply unit unattended.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power adaptor
cable to the device, and then connect the power adaptor to the power socket.
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
24. Do not wrap electric cable around the device.
25. Do not use a hair curling iron in the bath.
26. Do not remove dust or foreign bodies from the inside of the hair straightener using sharp
objects.
27. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
28. Do not cover the hair curling iron, it might cause the accumulation of heat in its interior
and it may cause damage or fire.
29. Hairsprays contain flammable materials. Do not apply them while using the device.
30. Do not use the device on people who are sleeping.
31. The device can be supplied only with the voltage specified on the housing.
32. During operation, do not place the device on wet surfaces or clothes.
33. After use, turn off and unplug the unit. Wait until the device cools down before storing.
34.During the operation ceramic plates heat up to high temperatures. Do not touch hot parts
of the hair curling iron and do not allow contact with the skin of the head, because it may
cause burns
35. The device is not designed to work with external schedulers or separate remote control
system.
DEVICE DESCRIPTION
1. Cool tip
4. Lever
7. Control light
10. Base
INSTRUCTIONS FOR USE
1. Connect the curling iron/straightener to the power. Place the device on the stand (10) in safe position.
2. Turn the curling iron/straightener on using the on/off switch (6)
STRAIGHTENING FUNCTION
1. Move the function selector (5) towards the handle.
2. Starting from the top of the head, pick a small strand of hair, and straighten it by combing.
3. Next, place the strand of hair between the heating plates (11), pressing the lever (4) to open them.
4. Move slowly, starting from the hair roots towards the tips.
5. Repeat with other strands of hair until all hair is straightened.
6. Wait until the hair cools, then comb it.
7. After use, switch the iron off with the on/off switch (6), then unplug it from the power source.
CURLING FUNCTION
1. Move the function selector (5) towards the heating plates.
2. Start with separating a strand of hair.
3. Open the clip (3) using the lever (4), place the strand of hair so that the hair ends protrude slightly beyond the clip. Close the clip.
4. Wind the hair strand around the curling iron wand, starting at the hair tips and moving closer to the head.
CAUTION: Avoid touching the head skin with the curling iron – this may cause burns.
2. Ceramic wand
5. Function selector
8. Hanging hook
11. Ceramic heating plates
3. Clip
6. On/off power switch
9. Swivel power cord
4