Philips SDV7700K/17 Manuel D'utilisateur page 4

Assembly
EN
6
All manuals and user guides at all-guides.com
• Insert UHF Boom-A into UHF Boom-B and secure using
1-1/2˝ screw and lock washer.
• Attach Reflector Arm Mounting Brackets to assembled UHF
Boom (previous step) using two 1-1/2˝ screws and wing-nuts.
Ensure that rotation arcs in Reflector Arm Mounting Brackets
face toward UHF Boom elements.
• Attach Corner Reflector Arms to Reflector Arm Mounting
Brackets by sliding Reflector Arms between Mounting
Brackets. Secure with 1-1/2˝ screw and wing-nuts. To fully
secure Reflector Arms, snap into locking tabs and tighten
screws.
Assembly of VHF Portion
• Rotate reflector element rods on VHF Boom-A and VHF
Boom-B into place. NOTE: When rotating element rods,
grasp close to pivot and relieve spring pressure on pivot
bracket detents. Don't apply excess pressure to reflector ele-
ment rods.
• Attach one 46˝ Element to hole A in VHF Boom-B.
• Attach one 50˝ Element to VHF Boom-B.
Repeat each steps with second boom for VHF Boom-B.
Assembly
• Insert VHF Boom-B into VHF Boom-A and secure using 1-1/2˝
screw and lock washers. Repeat steps for 2nd boom as well.
• Attach tubing brace to rear of VHF Boom with 1-1/2˝ screws
and wing-nuts.
• Slide UHF Boom through center slot of VHF Boom support
block until hole A of UHF Boom aligns with hole B of VHF
Boom. Secure with 1-1/2˝ screw and wing-nut.
• Attach phasing wire and lead-in wire to UHF antenna using
3/4˝ screws, washers, and wing-nuts.
• Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
• Assemble U-bolts to cross pieces.
• Use saddle on center of boom.
• Assemble U-bolt assemblies loosely to antenna.
• Insert mast through U-bolts.
• Tighten U-bolts securely. All U-bolts should be on one side
of mast.
• Attach mast standoff to mast.
• Insert wire in standoff and tighten with pliers.
• Power lines should be as far away as possible.
• Assemble U-bolts in wall mounts with lock washers and nuts.
• Secure mounts to wall with wood screws.
• Separate mounts by at least two feet.
• Insert mast with assembled antenna through both U-bolts.
• Face antenna toward TV station.
• Tighten U-bolts securely.
• Wall mounts and chimney mounts are not included.
E
7