EGAmaster 58770 Manuel D'instructions page 16

External View
5. RX led
6. Antenna
7. TX led
9. SET button
10. UP button
11. Down button
12. RC button
1. Power LED.
2. USB Jack.
3. Power Switch.
4. Buzzer.
5. RX LED will be on if data packet received.
6. Antenna.
7. TX LED will be on while transmitting data.
8. LCD display.
9. SET button:
- This button is used to enter the setting mode by press and hold for more than 1 second.
- While in setting mode, this button is used to loop through each setting.
10. Up button:
This is used to toggle on/off or increase the corresponded setting.
11. Down button:
This is used to toggle on/off or decrease the corresponded setting.
12. RC button: Reserved.
13. Power wiring terminals:
These terminals used to wire the power source.
16
EXTERNAL VIEW AND EACH PART NAME
8. LCD
13. Power terminals
1. Power LED
2. USB Jack
3. Power Switch
4. Buzzer