Important - Y-cam Shell Instructions De Montage

Y-cam Shell Assembly Instructions - English
Package Contents
A) x 3 – Stainless Steel Screws for Wall Mount Bracket
B) x 3 – Wall plug for Wall Mount Bracket
C) x 4 – Screws for Camera holding Plate (internal)
D) x 4 – Rubber Plugs
E) x 1 – Hex Key
F) x 1 – Y-cam Shell external enclosure

IMPORTANT

PLEASE INSPECT THE SEALS CAREFULLY WHEN ASSEMBLING THE Y-CAM SHELL SINCE AN INCORRECTLY SEATED
SEAL WILL ALLOW MOISTURE TO PENERTATE THE HOUSING AND DAMAGE THE CAMERA. THIS WILL ALSO VOID THE
WARRANTY OF BOTH THE HOUSING AND THE CAMERA.
• Using the supplied Hex Key, loosen the wall mounting bracket to allow easy access to the two screws holding the
back plates. (Fig 1)
• Unscrew the two screws (Fig 2) holding the curved back plates and remove the plates. (Fig 3 & 4)
• Remove the four screws holding the front to the main body of the Y-cam Shell (Fig 5)
• Carefully separate the two parts. (Fig 6)
For Y-cam Knight or Y-cam Black :
• Remove the four screws holding the front dome
(Fig 7)
• Remove the front dome making sure that the
rubber seal under the dome stays in its place. (Fig 8)
• Insert the Y-cam Black or Knight in the front part of
the housing, making sure that the camera dome is
seated properly on the front seal. (Fig 9)
IMPORTANT
PLEASE INSPECT THE SEALS CAREFULLY WHEN
ASSEMBLING THE Y-CAM SHELL SINCE AN
INCORRECTLY SEATED SEAL WILL ALLOW MOISTURE
TO PENERTATE THE HOUSING AND DAMAGE THE
CAMERA.
• Insert the holding plate with side B facing outwards
(Fig 10) and tighten the plate using the 4 supplied
screws (item C in package contents) (Fig 11)
• Connect the network and power cable (Fig 12)
• Carefully assemble the two halves back together (Fig 13) making sure that the rubber seal is seated properly and
that no part of the seal is pinched or out of place. (PLEASE INSPECT THE SEAL CAREFULLY SINCE AN INCORRECTLY
PLACED SEAL WILL ALLOW WATER OR MOISTURE TO LEAK IN AND DAMAGE THE CAMERA)
• Screw back the 4 screws removed in step 3 (Fig 14) and insert the rubber plugs in the screw holes.
• Place the two curved back plates in place and tighten the screws (Fig 15)
• Tighten the hex screw to the desired position (Fig 16) and inspect the housing (Fig 17) making sure that both seals
(front and middle) are both in place, seated correctly and not pinched.
For Y-cam White :
• Insert the Y-cam White in the front part of the
housing. (Fig 7w)
• Insert the holding plate with side A facing outwards
(Fig 8w) and tighten the plate using the 4 supplied
screws (item C in package contents) (Fig 11).